Acid loading test (pH)

How the test is performed:

A urine sample and a blood sample are needed to perform this test. The laboratory analyzes the samples for acid.

Child or adult:
Collect a "clean-catch" ("midstream") urine sample. To obtain a clean-catch sample, men or boys should wipe clean the head of the penis. Women or girls need to wash the area between the lips of the vagina with soapy water and rinse well. As you start to urinate, allow a small amount to fall into the toilet bowl (this clears the urethra of contaminants). Then, in a clean container, catch about 1 to 2 ounces of urine and remove the container from the urine stream. Give the container to the health care provider or assistant.

Infant:
Thoroughly wash the area around the urethra. Open a urine collection bag (a plastic bag with an adhesive paper on one end), and place it on your infant. For males, the entire penis can be placed in the bag and the adhesive attached to the skin. For females, the bag is placed over the labia. Place a diaper over the infant (bag and all). Check your baby frequently and remove the bag after the infant has urinated into it. For active infants, this procedure may take a couple of attempts--lively infants can displace the bag, causing an inability to obtain the specimen. The urine is drained into a container for transport back to the health care provider.

Adult or child:
Blood is drawn from a vein (venipuncture), usually from the inside of the elbow or the back of the hand. The puncture site is cleaned with antiseptic, and a tourniquet (an elastic band) or blood pressure cuff is placed around the upper arm to apply pressure and restrict blood flow through the vein. This causes veins below the tourniquet to distend (fill with blood). A needle is inserted into the vein, and the blood is collected in an air-tight vial or a syringe. During the procedure, the tourniquet is removed to restore circulation. Once the blood has been collected, the needle is removed, and the puncture site is covered to stop any bleeding.

Infant or young child:
The area is cleansed with antiseptic and punctured with a sharp needle or a lancet. The blood may be collected in a pipette (small glass tube), on a slide, onto a test strip, or into a small container. Cotton or a bandage may be applied to the puncture site if there is any continued bleeding.

How to prepare for the test:

Take ammonium chloride capsules orally for 3 days prior to the test. Then a sample of urine and blood are taken (see above). The blood sample is necessary to prove that the ammonium chloride had the desired effect of making the blood slightly acidic.

How the test will feel:

When the needle is inserted to draw blood, some people feel moderate pain, while others feel only a prick or stinging sensation. Afterward, there may be some throbbing.

Why the test is performed:

The test checks the ability of the kidneys to regulate acid-base status.